Race Ramps Restyler - 16"

• Elevates the vehicle so as you can easily access lowers parts, eg: bumpers and sills
• Easy to store, move and take on site
• Save your back and work comfortably
• Save time - work efficiently - fewer ups and downs
• Look professional – also great for shots of a finished wrap

 

 

 

Featuring an angle of approach of 10.36 degrees, the ramp system is available in a 16″ /40cm width (for tyres up to 14″ wide) and a 20″/50cm width (for tyres up to 18″/460mm wide). The system accommodates wheelbases from 82″/208cm to 128″/325cm

Each Restyler Ramp consists of five interlocking pieces that combined weigh only 50kgs, with no one piece weighing more than 19kgs. Once the vehicle is safely on the blocks, the centre “bridge” piece can be removed from each side for easier access underneath the car – or for use as a bench or step stool for more convenient access to the whole vehicle. The incline portion can also be removed for greater accessibility around the car.  For ultimate ease loading and unloading, you can purchase a second set of inclines for the 16″/40cm width to place at the front of the ramp setup, allowing you to smoothly drive up and down on both ends without needing to move any inclines.

Steel strips are built into the ramp for directly holding magnetic tools and/or a magnetic shelf.

The ramp system has a total vehicle weight capacity of 6,000 lbs/2720 kgs and comes with one pair of inclines. For either width, an additional set of inclines is available that will interlock to the front and enable a vehicle to smoothly drive up and down both ends. This convenient and portable setup is great for use in the shop as well as when you’re on-the-go to other job locations.

If you’re working with cars really low to the ground (Lamborghinis and Ferraris), the optional XTenders will decrease your angle of approach to only 6.8 degrees, allowing you to work on virtually any car.

 

As always with Race Ramps products, the ramps are 100% solid and are made from a high-density expanded polystyrene which has been coated with a hybrid polyurea. This results in ramps which are extremely lightweight while being strong and durable.

 

Despite being lightweight, the ramps will not slide causing scratches or marks on the floor, as well as ensuring that the vehicle can be driven up with confidence. 

 

• Full-length 14"/35cm lift for vinyl wrapping, detailing, display, or maintenance
• 16"/40cm or 20"/50cm ramp width options
• 82"/208cm to 128"/325cm adjustable wheelbase
• Five modular sections per ramp, no piece more than 19kgs
• Set of two full ramps
• The Restyler ramps are supplied as a pair and include two 10.36 degree ramps, four wheel stands, two centre bridge pieces and two end stops.